The core barrel is the tool that receives the core. The choice between single, double and triple tube decides how much of the sample reaches the surface intact, which affects RQD, recovery and report quality.
Single tube barrel
It is one tube. The drilling fluid flows in direct contact with the core, and the tube rotates with the bit. It works in very sound, hard rock, where erosion and rotation do little harm. In fractured or soft rock, the fluid washes and wears the core.
Double tube barrel
It has an outer tube, which rotates with the bit, and an inner tube that stays still or turns freely on a bearing. The core enters the inner tube and is protected from fluid and rotation. It is the most common choice in geotechnical work and suits rock of medium to good quality.
Triple tube barrel
In addition to the two tubes, it uses an inner liner, often split, that receives the core. At the surface the liner is opened or removed whole, so the core is barely handled. It is the option for highly fractured, weathered, friable rock or rock with clay in the fractures.
Quick comparison
Type | Core protection | Typical use |
|---|---|---|
Single | Low | Sound, hard, continuous rock |
Double | Good | General geotechnical use |
Triple | Very good | Fractured, weathered or friable rock |
Other factors that affect recovery
- Feed rate and bit pressure, adjusted to the material.
- Flow and type of fluid, which must clean without eroding the core.
- Run length: long runs in poor rock risk blocking the tube.
- Condition of the bit and the core catcher.
Always record the barrel type on the log. Also read RQD: what it is and how to calculate it and core sizes. See Diamond Drill rotary and multifunction rigs.
{{t.k50}}
Diamond Drill manufactures drilling rigs. Talk to our technical team and find the right solution for your work.
